Front Fender riser kit Engineering

[GIDEON]

Ill send to you both the files as soon as the workplace server gets a wake-up if it still of tomorow ill safe it and bring them home and send them

[firecat0_0]

Thanks, that would be great! cheers

[SMIFFXC]

Just checking to see if I can get this picture to work.   

[SMIFFXC]

Well look at that, it worked!     Amazing what you can do at 3:25 AM!  The one thing I would say is to make sure you round off the small brackets good so they will fit into the bracket on the bike.  If you try to square them off they won't fit.  Now I will try to post some pic's of them on the bike.....

[SMIFFXC]

You will need to drill a hole between the two existing holes.  I left the reflector on to cover the rear brackets.  I used all existing hardware so I only had to buy 4 S/S screws, nylon lock nuts and washers.

[SMIFFXC]

Here are pic's of the fender height above the stock tire.  I have the rear fender extender on as well.  Sorry for the poor quality of the pic's, taken from my phone.

[GIDEON]

Go SMIFFXC we believe in you and it worked 

[SMIFFXC]

Originally Posted by GIDEON

Go SMIFFXC we believe in you and it worked 

Thanks for the vote of confidence!     Also, I should mention that the screws I used were about 12MM long.  That worked out well as they don't stick out the back of the nut much at all.

[firecat0_0]

Originally Posted by SMIFFXC

Just checking to see if I can get this picture to work.   

 :062:Thank you SMIFFXC

All the best

[ws888]

Thanks SMIFFXC, I knew it couldn't be too difficult! When I finally get my bike I will definitely do it.